R.E.S.I.

Job Building Storey 0.000 m

Draw

Snapping

Snap to drawing vertices Snap to wall ends Snap to grid Enable Shift ortho lock Grid size (m) Auto-slab on closed loop

Type a command anywhere, then Enter · use HELP for the full list
Click place point · Shift ortho lock when enabled · Enter finish
Ctrl+click adds to the selection; commands reuse the current selection
Esc cancel run, then clear selection, then pointer
Drag to orbit, wheel to zoom, right-drag to pan.

View controller Model

Every element in its construction’s own colour, one masonry pattern throughout.

Coordination

Masonry specification

Structural systems

Geometry checks

Annotations

Refine the current preset. Selecting it again restores its standard layer state.

Wall datums Junction angles Span directions Load vectors Load tables Wall references

Underlay

Drawing units

The underlay stays in your browser. It is what you trace over, not part of the shared model.

Layers

No drawing loaded.

Job

Buildings

Name

A job is a terrace or a pair of semis: loads run down one building and stop there.

Storeys

Floor-to-floor (m)

1 of 4

Profiles

Nothing selected.

Profile

This storey

Overall is measured over the wall faces, in millimetres, like the outer dimension string on a setting-out plan.

Walls

Length × thickness. Click a row to select the wall.

Floors

Model

Walls 0 · Slab zones 0
Roofs 0 · Foundations 0
Wall length 0.00 m · Floor area 0.00 m²
Wall volume 0.00 m³

Layout

Panel sizes and tabs are remembered in this browser only, like the underlay and your active storey.

Loads

Execution ? Units ? M_mid/M_head ? γ_G ? γ_Q ?

Profiles

Nothing selected

Materials

Assembly

Bearing ? Cavity (mm) ? Parallel-wall edge-strip width (mm) ? Set out ?

Pick something on the left.

Site ?

Stratum p_allow (kN/m²) ? Density (kg/m³) ?

Depth — NHBC 4.2 ?

Modified PI (%) ? Volume change ? Climate allowance (m) ? Use allowance Apply

Foundation review

Lintel reactions

A cross means the 45° masonry arch cannot form. Click an opening reference to select its host wall.

Command:

X 0.000 Y 0.000 connecting… Select